The pedal size is 230X70mm

Electrical angle 20 degrees

High sensitivity non-contact sensor

Provide high-precision output signals according to customer needs

Working voltage: 5V ± 0.5;

The maximum working current is 25mA;

The static thrust acts on a point 150mm away from the center axis of the pedal and is perpendicular to the surface of the pedal (initial pressure: 10N~minimum, throttle fully open: 45N~maximum);

Product protection level: IP=67;

Service life: 5000W times;

Salt spray test for 72 hours;

Working temperature: -40 ℃~125 ℃;

This product uses a non-contact Hall chip as the control unit, and the output curve can be adjusted freely. The entire control unit has reverse power polarity protection function and can withstand reverse voltage for up to 10 minutes. The sensor adopts independent dual Hall sensors, and the overall sealing treatment is filled with glue. It has two reset springs, and the left and right springs assist each other to reset the pedal, and imported materials are used.